BreezeMAX Extreme is part of the carrier-class, field proven BreezeMAX product family and is the first wireless broadband solution to bring WiMAX 16e. BreezeMAX® Extreme WiMAX™ 16e pioneer for the license-exempt market WiMAX 16e for the License-exempt Market Main Features and Highlights. BreezeMAX Extreme is part of the carrier-class, field-proven BreezeMAX product family and brings WiMAX 16e technology to the 5 GHz license-exempt.
|Published (Last):||26 September 2009|
|PDF File Size:||7.24 Mb|
|ePub File Size:||10.51 Mb|
|Price:||Free* [*Free Regsitration Required]|
Under dual sector SISO base-station, running a spectrum analyzer on one 50000 may lead as part of the scanning to BTS restart affecting the operation of the second sector.
Two service flows which have the same priority are equalized by the CPE at packet rates and not bit rates the packet sizes are bgeezemax taken into account. When the sum of all provisioned services exceeds the CPE license capacity, the NE process will not be completed.
NE failure when provisioning a capacity limit CPE model with services sum exceeding the capacity limit. The CPE will provision the services according to the order in which they are received until the license is exceeded.
Such DSCP values might interfere with the feature. In case of using country code with DFS: Any service modification requires MS de-registration in order to take place. Under GPS chaining, when there is a faulty chaining cable, the radio units in the chain may not initiate transmission. Known Issues and Limitations With Release 1.
BreezeMAX® Extreme 5000
After link with BTS is established, the new version is Set as main automatically by the device For details on the required changes, please refer to the application note: Upgrade also the CPE to Release 1.
It is important to design carefully the frequency allocations and potential bands e. Ping messages of bytes transmitted over R1 to the host behind CPE are sometimes unanswered.
This is mainly since IP address When performing backhauling over Extreme CPE i. Due to the requirements of FCC regulations, starting with release 1. Network entry timeout prevent s full band scan in universal CC, thus workaround is needed to set only one BW to scan. Please note that applying factory defaults will not change Country Code selection. De-register the MS to have the new setting in affect CSassociate to it the forwarding rule you’ve created in step ‘b’.
Rocket M5 vs Alvarion BreezeMAX Extreme – Ubiquiti Networks Community
When running Spectrum Analyzer while operating in dual sector mode, if system had developed misssynchronization because of GPS holdover, at the end of the scan process the system would reinitialize both channels. No disclosure thereof shall be made to third parties without the express written permission of Alvarion.
In very rare occasions, the logical BS ID might be reinitiated. When upgrading to release 1. Such cases might occur when using limited license CPEs and the total number of services defined for such a CPE is above the licensed value.
BreezeMAX® Extreme (BreezeMAX Extreme ) |
The Ethernet port supports only Auto Negotiation mode. Software is downloaded to the unit b. Although mentioned in recommendation 20, when operating in release 1. As part of these changes, several additional configuration options are available, such as: Define new service interface as Eth.
The material contained herein is proprietary, privileged, and confidential. When connection with AAA is reestablished the entire cell will be authenticated again automatic de-registration of all CPE.
The documentation includes the following: Base Station ID configured in each channel must be unique in breeezmax entire network. The following is a general description: Aradial default installation of version 5.
The information is not submitted through the TR protocol. Upon successful completion the unit set automatically “run from shadow” and performs reset itself.